![\"\"](\"https:\/\/opentextbc.ca\/physicalgeology2ed\/wp-content\/uploads\/sites\/298\/2019\/06\/image027.png\")
<\/a> Figure 7.4.1 Metamorphic index minerals and their approximate temperature ranges <\/a> Figure 7.4.1 Metamorphic index minerals and their approximate temperature ranges [Image Description]<\/a>[\/caption]The southern and southwestern parts of Nova Scotia were regionally metamorphosed during the Devonian Acadian Orogeny (around 400 Ma), when a relatively small continental block (the Meguma [pb_glossary id=\"1548\"]Terrane[\/pb_glossary]<\/strong>[footnote]No, it\u2019s not a spelling mistake! A terrane is a distinctive block of crust that is now part of a continent, but is thought to have come from elsewhere, and was added on by plate-tectonic processes.[\/footnote]) was pushed up against the existing eastern margin of North America. As shown in Figure 7.4.2, clastic sedimentary rocks within this terrane were variably metamorphosed, with the strongest metamorphism in the southwest (the sillimanite zone), and progressively weaker metamorphism toward the east and north. The rocks of the sillimanite zone were likely heated to over 700\u00b0C, and therefore must have buried to depths between 20 and 25 kilometres. The surrounding lower-grade rocks were not buried as deep, and the rocks within the peripheral chlorite zone were likely not buried to more than about 5 kilometres.\r\n\r\n[caption id=\"attachment_322\" align=\"aligncenter\" width=\"650\"]![\"\"](\"https:\/\/opentextbc.ca\/physicalgeology2ed\/wp-content\/uploads\/sites\/298\/2019\/08\/meguma-map-2.png\")
<\/a> Figure 7.4.2 Regional metamorphic zones in the Meguma Terrane of southwestern Nova Scotia.[\/caption]\r\n\r\nA probable explanation for this pattern is that the area with the highest-grade rocks was buried beneath the central part of a mountain range formed by the collision of the Meguma Terrane with North America. As is the case with all mountain ranges, the crust became thickened as the mountains grew, and it was pushed farther down into the mantle than the surrounding crust. This happens because Earth\u2019s crust is floating<\/span> on the underlying mantle\u2014and that is known as an isostatic relationship. As the formation of mountains adds weight, the crust in that area sinks farther down into the mantle to compensate for the added weight. The likely pattern of metamorphism in this situation is shown in cross-section in Figure 7.4.3a. The mountains were eventually eroded (over tens of millions of years), allowing the crust to rebound upward, thus exposing the metamorphic rock (Figure 7.4.3b).\r\n\r\n[caption id=\"attachment_323\" align=\"aligncenter\" width=\"650\"]![\"\"](\"https:\/\/opentextbc.ca\/physicalgeology2ed\/wp-content\/uploads\/sites\/298\/2019\/08\/image029.png\")
<\/a> Figure 7.4.3a Schematic cross-section through the Meguma Terrane during the Devonian period. The crust is thickened underneath the mountain range to compensate for the added weight of the mountains above and has sunk into the mantle.[\/caption]\r\n\r\n[caption id=\"attachment_324\" align=\"aligncenter\" width=\"650\"]![\"\"](\"https:\/\/opentextbc.ca\/physicalgeology2ed\/wp-content\/uploads\/sites\/298\/2019\/08\/image030.png\")
<\/a> Figure 7.4.3b Schematic present-day cross-section through the Meguma Terrane. The mountains have been eroded. As they lost mass the base of the crust gradually rebounded, pushing up the core of the metamorphosed region so that the once deeply buried metamorphic zones are now exposed at surface.[\/caption]\r\n\r\nThe metamorphism in Nova Scotia\u2019s Meguma Terrane is just one example of the nature of regional metamorphism. Obviously many different patterns of regional metamorphism exist, depending on the parent rocks, the geothermal gradient, the depth of burial, the pressure regime, and the amount of time available. The important point is that regional metamorphism happens only at significant depths. The greatest likelihood of attaining those depths, and then having the once-buried rocks eventually exposed at the surface, is where mountain ranges existed and have since been largely eroded away. As this happens typically at convergent plate boundaries, directed pressures can be strong, and regionally metamorphosed rocks are almost always foliated.\r\nExercise 7.4 Scottish metamorphic zones<\/p>\r\n\r\n<\/header>\r\n
![\"\"](\"https:\/\/opentextbc.ca\/physicalgeology2ed\/wp-content\/uploads\/sites\/298\/2019\/06\/exercise-7-4.jpg\")
<\/a> Figure 7.4.4[\/caption]\r\n\r\nThe map shown here represents the part of western Scotland between the Great Glen Fault and the Highland Boundary Fault. The shaded areas are metamorphic rock, and the three metamorphic zones represented are garnet, chlorite, and biotite.\r\n\r\nLabel the three coloured areas of the map with the appropriate zone names (garnet, chlorite, and biotite).\u00a0 Hint: refer to Figure 7.4.1 above to work out which of these zones might represent the peripheral area of low-grade metamorphism, and which might represent the core area of higher-grade metamorphism.\r\n\r\nIndicate which part of the region was likely to have been buried the deepest during metamorphism.\r\n\r\nBritish geologist George Barrow studied this area in the 1890s and was the first person anywhere to map metamorphic zones based on their mineral assemblages. This pattern of metamorphism is sometimes referred to as \u201cBarrovian.\u201d\r\n\r\nSee Appendix 3 for Exercise 7.4 answers<\/a>.\r\n\r\n<\/div>\r\n<\/div>\r\nAs described above, regional metamorphism occurs when rocks are buried deep in the crust. This is commonly associated with convergent plate boundaries and the formation of mountain ranges. Because burial to 10 to 20 kilometres is required, the areas affected tend to be large\u2014thousands of square kilometres.<\/p>\n
Rather than focusing on metamorphic rock textures (slate, schist, gneiss, etc.), geologists tend to look at specific minerals within the rocks that are indicative of different grades of metamorphism. Some common minerals in metamorphic rocks are shown in Figure 7.4.1, arranged in order of the temperature ranges over which they tend to be stable. The upper and lower limits of the ranges are intentionally vague because these limits depend on a number of different factors, such as the pressure, the amount of water present, and the overall composition of the rock.<\/a><\/p>\n The southern and southwestern parts of Nova Scotia were regionally metamorphosed during the Devonian Acadian Orogeny (around 400 Ma), when a relatively small continental block (the Meguma Terrane<\/a><\/strong>[1]<\/sup><\/a>) was pushed up against the existing eastern margin of North America. As shown in Figure 7.4.2, clastic sedimentary rocks within this terrane were variably metamorphosed, with the strongest metamorphism in the southwest (the sillimanite zone), and progressively weaker metamorphism toward the east and north. The rocks of the sillimanite zone were likely heated to over 700\u00b0C, and therefore must have buried to depths between 20 and 25 kilometres. The surrounding lower-grade rocks were not buried as deep, and the rocks within the peripheral chlorite zone were likely not buried to more than about 5 kilometres.<\/p>\n A probable explanation for this pattern is that the area with the highest-grade rocks was buried beneath the central part of a mountain range formed by the collision of the Meguma Terrane with North America. As is the case with all mountain ranges, the crust became thickened as the mountains grew, and it was pushed farther down into the mantle than the surrounding crust. This happens because Earth\u2019s crust is floating<\/span> on the underlying mantle\u2014and that is known as an isostatic relationship. As the formation of mountains adds weight, the crust in that area sinks farther down into the mantle to compensate for the added weight. The likely pattern of metamorphism in this situation is shown in cross-section in Figure 7.4.3a. The mountains were eventually eroded (over tens of millions of years), allowing the crust to rebound upward, thus exposing the metamorphic rock (Figure 7.4.3b).<\/p>\n The metamorphism in Nova Scotia\u2019s Meguma Terrane is just one example of the nature of regional metamorphism. Obviously many different patterns of regional metamorphism exist, depending on the parent rocks, the geothermal gradient, the depth of burial, the pressure regime, and the amount of time available. The important point is that regional metamorphism happens only at significant depths. The greatest likelihood of attaining those depths, and then having the once-buried rocks eventually exposed at the surface, is where mountain ranges existed and have since been largely eroded away. As this happens typically at convergent plate boundaries, directed pressures can be strong, and regionally metamorphosed rocks are almost always foliated.<\/p>\n Exercise 7.4 Scottish metamorphic zones<\/p>\n<\/header>\n The map shown here represents the part of western Scotland between the Great Glen Fault and the Highland Boundary Fault. The shaded areas are metamorphic rock, and the three metamorphic zones represented are garnet, chlorite, and biotite.<\/p>\n Label the three coloured areas of the map with the appropriate zone names (garnet, chlorite, and biotite).\u00a0 Hint: refer to Figure 7.4.1 above to work out which of these zones might represent the peripheral area of low-grade metamorphism, and which might represent the core area of higher-grade metamorphism.<\/p>\n Indicate which part of the region was likely to have been buried the deepest during metamorphism.<\/p>\n British geologist George Barrow studied this area in the 1890s and was the first person anywhere to map metamorphic zones based on their mineral assemblages. This pattern of metamorphism is sometimes referred to as \u201cBarrovian.\u201d<\/p>\n See Appendix 3 for Exercise 7.4 answers<\/a>.<\/p>\n<\/div>\n<\/div>\n <\/a>Figure 7.4.1 image description:<\/strong> Approximate temperature range of metamorphic minerals: Chlorite, 50 to 450\u00b0C. Muscovite, 175 to 625\u00b0C. Biotite, 350 to 725\u00b0C. Garnet, 375 to 900\u00b0C. Andalusite, 400 to 850\u00b0C. Sillimanite, 575 to 1000\u00b0C. [Return to Figure 7.4.1]<\/a><\/p>\n a block of crust that has geological features that are distinctive from neighbouring regions, and is assumed to have been moved from elsewhere by tectonic processes<\/p>\n<\/div><\/a><\/a><\/a><\/a>\n\n<\/a>Image Descriptions<\/h3>\n
Media Attributions<\/h3>\n
\n
definition<\/span>